Bursting testing machine is a kind of testing machine which is mainly used to conduct hydraulic tests of metallic conduits, nonmetallic conduits steel tubes and pressure vessels, such as steel tubes and titanium tubes. And bursting testing machine can be used to conduct both withstand voltage test and explosion bulge test. Hydrostatic bursting testing machine is a typical type of bursting testing machine. Bursting testing machines are extensively applied to conduct the static testing and dynamic testing of aircraft engine accessories and the performance test of automobile braking system. In addition, bursting testing machine can be used to produce pressures in order to examine or calibrate mechanical components. Because of its extensive uses, bursting testing machine has become increasingly engaged with our daily life and its operation cautions and maintainance have drawn more and more attention from the public.

To use a bursting testing machine safely and effectively, here are some operation cautions centring on its operation.

1. Do not launch a bursting testing machine when there is no fluid in its fluid reservoir.   

2. Do not take down its test pieces or pipe lines when a bursting testing machine is under stress.

3. Never unplug a bursting testing machine's power line when it is in power-up state.

4. Except for the printed driver, do not install any other procedures on a bursting testing machine's computer.

5. Do not run any other procedures when a bursting testing machine's specific programs are in operating state.

Besides its operation cautions, bursting testing machine's maintainance is also something we should pay close attention to. And for better maintainance of bursting testing machines, here are some tips that can be helpful to us. And it is important for us to abide by the following tips.

1. Just like using a hydrostatic burst tester, you should also regularly examine bursting testing machines to guarantee the completeness of their components and parts.

2. Termly change bursting testing machines' test medium and clean up their fluid reservoirs at fixed periods.

3. After each withstand voltage test or explosion bulge test, clean up bursting testing machines' test chambers. And when cleaning their test chambers, remember to clean up the bottom of their oil cylinders.

4. Every time a bursting testing machine has been continuously running for more than 8 hours, drain out the water in its filter otherwise the water and impurities in its filter will flow into the bursting testing machine's driving cylinder and damage the seal rings there.

5. Termly check up whether there are enough oils in a bursting testing machine's atomized lubricator so that you can refuel the bursting testing machine in time.